The Electrical HER platform is a 3 dimensional platform with a swivelling arm, designed for use in paint spray booths to allow an additional level of access. The platform travels on rails with the option of operating the swivelling arm manually.
The cage is designed for carrying two operatives and relevant equipment with a maximum load capacity of 200kg.
The platform has many safety features including emergency decent, load measurement to protect against overloading, safety net under cage, self-closing access doors and ground controls.
The controls are situated within the cage and operate the platform for vertical, horizontal in/out movement.
Inner width Cage
Inner length Cage
Rails and accessories inside/outside booth
The following items are required in the booth:
The upperrail on both sides of the booth
The bottom rail above the servicedoors
Cable trolley for all cables
Electrical cables and pneumatice piping (optional)
The following items are required outside the booth:
All electrical cables to the board
The cage of platform
The cage of the HE platform is made of mechanically welded tubes. The floor is a slip resistant gratings. The platform is surrounded with railings and a baseboard.
The access door is located on the side of the platfom and have the same height as the railings. The door open to the inside and close automatically thanks to a spring located in the hinge.
The cage is designed to lift up 2 persons and his equipment (200kg). On demand a light unit 2x58W ATEX can be mounted on the top of the platform
Operations and movements
A control box a the back of the cage (optional with foot pedals) grants the operator the ability to move the platform in the desired direction, vertical movement (up/down) is done by electrical motor (ATEX), where as the horizontal movement (in/out) is done with scissors. the movement longwise the walls of the booth is by electrical motor (EX-version)
Regulations and safety
The platforms HE are CE-approved and complies with the requirements for the use in explosive atmospheres (ATEX zone 2 Cat. 3G/D). Each platform has by default the following safety measurements:
Emergency descent in case of power failure
Hand winch for retracting scissors when power failure
Loading measuring device against overweight
Safety net under the cage against obstacles on the ground
Self closing hinges against unwanted opening of the access doors
Safety measures required by ATEX regulations
Up / Down
max 4m / min
Left / Right
max 9m / min